Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CLIMATIC CLASS
SN
N
ST
T
3. Installation
3.1 Site
1. Unpack the appliance carefully. Dispose of the packaging as described in
chapter waste management.
2. Completely remove the transport-protection (adhesive tape) of the accessories.
Be very careful and do not use any aggressive or abrasive detergents to remove
residuals of the transport-protection.
3. Install the appliance in a suitable position with an adequate distance from
sources of heat and cold.
4. Check that the appliance and the power cord are not damaged.
5. Install the appliance in a dry and well-ventilated place.
6. Protect the appliance from direct sunlight.
7. The doors must open completely and without hindrance.
8. Install the appliance on a level, dry and solid floor. Check the correct installation
with a bubble level.
9. Connect the appliance to the mains properly.
10. The nameplate is situated inside the appliance or at the back.
3.2 Installation
The dimensions of the appliance are registered in chap. T
note the information given in Additional side-attachment at the end of this
section. Carry out the installation with at least 2 persons..
AMBIENT TEMPERATURE
+10
0
→+32
0
C
e.g. unheated cellar
+16
0
→+32
0
C inner home temperature
+16
0
→+38
0
C inner home temperature
+16
0
→+43
0
C inner home temperature
ECHNICAL
D
. Please
ATA
37
Werbung
Inhaltsverzeichnis
Fehlerbehebung
