Specified Conditions Of Use; Angle Grinder Safety Warnings - AEG BEWS18-115BLPX2 Übersetzung Der Originalanleitung

EN ORIGINAL INSTRUCTIONS

SPECIFIED CONDITIONS OF USE

The product is designed for grinding and cutting metals and
stone materials. Only appropriate grinding and cutting wheels
The product is intended for dry use only. Do not use the product for
wet applications.
The product is designed for handheld use. The product is not to be
mounted onto a workbench.
Do not use the product for any other purpose.
WARNING! Read all safety warnings, instructions,
Failure to follow all instructions listed below may result in electric

ANGLE GRINDER SAFETY WARNINGS

operations:
Operations for which the power tool was not designed may create a
Such a conversion may result in a loss of control and cause serious
accessory can be attached to your power tool, it does not assure
safe operation.
Incorrectly sized accessories cannot be adequately guarded or
controlled.
Accessories that do not match the mounting hardware of the power
tool will run out of balance, vibrate excessively and may cause loss
of control.
inspecting and installing an accessory, position yourself and
Damaged accessories will normally break apart during this test
time.
The eye protection must be capable of
by the particular application. Prolonged exposure to high intensity
noise may cause hearing loss.
Fragments of workpiece or of a broken accessory may
8
metal parts of the power tool "live" and could give the operator an
electric shock.
and pull the power tool out of your control.
Accidental contact with the spinning accessory could snag your
clothing, pulling the accessory into your body.
draw the dust inside the housing and excessive accumulation of
powdered metal may cause electrical hazards.
Sparks could ignite these materials.
water or other liquid coolants may result in electrocution or shock.
Kickback is a sudden reaction to a pinched or snagged rotating
wheel, backing pad, brush or any other accessory. Pinching or
snagging causes rapid stalling of the rotating accessory which in
turn causes the uncontrolled power tool to be forced in the direction
opposite of the accessory's rotation at the point of binding.
Failure to follow
For example, if an abrasive wheel is snagged or pinched by the
workpiece, the edge of the wheel that is entering into the pinch
point can dig into the surface of the material causing the wheel
away from the operator, depending on the direction of the wheel's
movement at the point of pinching. Abrasive wheels may also
break under these conditions.
operating procedures or conditions and can be avoided by taking
proper precautions as given below.
Just because the
Accessories running
operations:
for which the power tool was not designed cannot be adequately
guarded and are unsafe.
cannot be adequately protected.
the operator from broken wheel fragments, accidental contact with
wheel and sparks that could ignite clothing.
applied to these wheels may cause them to shatter.
Contact with a "live" wire will also make exposed
The spinning accessory may grab the surface
The operator can control torque reactions or
kickback forces, if proper precautions are taken.
Accessory may kickback over your hand.
in direction opposite to the wheel's movement at the point of
snagging.
sharp edges or bouncing have a tendency to snag the rotating
accessory and cause loss of control or kickback.
uch blades create frequent kickback
and loss of control.
The motor's fan will
Using
Kickback will propel the tool
Corners,
Wheels
An improperly
The guard helps to protect
Abrasive