Risks Due To Accessories; Safety Measures At The Installation Site; Risks From Structural Changes And Replacement Parts; Permissible Water Values - Behncke BUHNE 2 Betriebsanleitung

Filter tank BÜHNE² / General information and safety information

2.6 Risks due to accessories

Only accessories from BEHNCKE
Accessories must not endanger the safety of the system.

2.7 Safety measures at the installation site

The filter tank must be stably mounted on a level and solid surface or on a mounting plate and is not
suitable for use in constant sunlight.
Make sure that the maximum operating pressure of 2.5 bar and operating temperature of 40°C are not
exceeded.
Only run the system if all the safety devices are fully functional.
The installation space must not be colder than 5°C during operation, maintenance, start-up, cleaning and
repair.
There must be a sufficiently large floor drain in the installation room to avoid water damage if there are any
leaks.
The installation room must not have an explosive atmosphere.
The tank or surroundings may be damaged if this is not followed.

2.8 Risks from structural changes and replacement parts

Structural changes may affect operational safety. As a result, the filter tank may only be converted or
modified in written agreement with the manufacturer. No components, especially safety devices, may be
removed.
Only replacement parts and accessories from BEHNCKE
Any accessories must not endanger the safety of the system.

2.9 Permissible water values

Water in swimming/bathing pools or swimming/bathing ponds must not exceed or fall short of the follow-
ing values.
6
®
may be used.
DANGER
Check the system for leaks, externally-visible damage and functionality
at least once a week while the pool is running.
Chloride
Free chlorine content
pH value
Iron
Copper
Salt content
Temperature
Langelier index
®
may be used.
max. 500 mg/l
max. 1.3 mg/l
min. 6.8
max. 8.2
max. 0.1 mg/l
max. 0.2 mg/l
max. 3.5%
max. 40°C
from -0.3 – +0.3