Coccolle Amani Bedienungsanleitung Seite 7

EN
• Damage occurred as a result of failure to observe maintenance guidelines
such as: corrosion, changed upholstery or plastic elements colour as a result of
prolonged exposure to sunlight, damage to plastic elements of upholstery as a
result of prolonged exposure to sunlight or excessive temperatures, excessive
play, squeaking / creaking noises, damage to mechanism due to over-load.
• Damage occurred due to repairs being carried out by unauthorised personnel.
• Single wheels being pushed into a vertical position as a result of loading (this
is normal).
• Damage and soiling occurred due to the product being incorrectly packaged for
shipping (courier online purchases).
2. The repair method is determined by the manufacturer/warranty service
provider.
3. The product subject to a complaint should be provided clean.
4. The consumer goods warranty does not exclude or suspend the purchaser's
rights stemming from goods noncompliance with the agreement.
I. Assembly
Pic.1-3: Open the carton, take off the poly bag and pull out the stroller carefully.
Take out of the two in one seat and stretch it out to a flat position pic.2.
Pic.4-5: Open the canopy.
Pic.6-7: Press the buttons on the seat adapter post and turn the adapter
straight.
Pic.8-10: Pull the metal bar under the seat along with the seat post, then the
seat is open pic.10.
Pic.11-12: Grip the handle bar and lift the stroller frame up pic.11 to open the
frame pic.12.
Pic.13: Insert the two front wheels into the plastic holes until "click" sound can
be heard after the front wheel is fixed.
Pic.14: Press the plastic button at side to detach the front wheel.
Pic.15-16: Press down the button direction lock to lock the wheel. Simply move
the lock up to release it and have the wheel swiveling.
Pic.17: Match the axle on the rear wheel with the housing on the frame and
insert it until you hear a "click" sound.
Pic.18: Pull out the metal sheet and in the same time with the other hand pull
out the rear wheel to detach it.
Pic.19: Step on the rear brake lever to stop the stroller and lift it up to release
the lock of the brake.
Pic.20: Fasten the snap fastener under the seat over the metal bar as shown.
Pic.21: Match the ready two in one seat unit with the slots on the frame and
insert it until you hear a "click" sound.
Pic.22-23: Get the front bumper and match it with the slots on the seat until you
hear a "click" sound to install it. Press the button on both sides of the bumper to
detach it.
Pic.24: To convert the sleeping mode to the seat mode, fasten the two buckles
under the seat unit as shown.
Pic.25-26: Move the buckle under the recline part with the belt upward to make
the upright position for the seat. Move it downward to release it.
7