Hendi 239872 Bedienungsanleitung Seite 7

• Ensure that there is sufficient ventilation. Keep a
minimum distance of 15cm around the appliance
bottom of cookware
• Do not place the appliance in close proximity to
devices which are sensitive to disturbances by
magnetic sources (e.g. radios, tape decks).
Suitable cooking equipment
Bottom of cookware
Material
Diameter of the 239698
bottom
239711
239872
Type of cookware
Note: Using a pan or pot that's not suitable for induction cooking may damage the appliance.
Operation
• Put the plug in the socket.
• Set the pan of your choice on the cooking surface,
bearing the above-mentioned instructions in
mind. NOTE! Make sure that the pans are cover-
ing the indicated zones at all times during use in
order to prevent the appliance from getting dam-
aged. Do not leave your pan on the burner while
empty as this may lead to damage to your pans.
• Switch the appliance on by pressing the "ON/
OFF" and then the "ARROW UP" key. If your pan
is suitable for induction and has a bottom diam-
eter of 14 cm, at minimum, the appliance will go
into operation. You will recognise this from the
fact that the fan will go on and the display will
show a capacity position of "2000". NOTE! If the
appliance beeps after being switched on, the pan
you are using is not suitable for induction or the
appliance is defective. In case of any doubt, al-
ways contact the supplier of your pan!
• Once the appliance is operating and the display
indicates position "2000", you can programme
the appliance in one of the following two ways:
1. Capacity control: You can control the perfor-
Suitable
Flat bottom
Cookware with iron, cast iron, magnetic stainless
steel or enamelled iron bottom.
Between 16 cm and 30 cm.
Between 14 cm and 28 cm.
Cookware with a bottom thickness over 1.5 mm.
Note: Due to manufacturing residues, the appli-
ance may emit a slight odor in the first few cycles.
This is normal and does not indicate any defect or
hazard. Make sure the appliance is well ventilated.
Not suitable
Curved, uneven, rounded bottom
Cookware with ceramic, glass, copper,
bronze, or aluminium bottom.
Less than 16 cm or more than 30 cm.
Less than 14 cm or more than 28 cm.
Completely closed containers or cans.
mance of the appliance, just as for a gas cooker
via 17 positions ranging from 100W to 3500W.
The default position for the appliance is "2000".
2. Temperature control: you can set the tempera-
ture between 35°C and 240°C in 5°C increments.
Standard position for the appliance is 100°C. AT-
TENTION! The programmed temperature is that
of the glass plate and not the temperature in the
pan!
• If you choose capacity control, select "heating"
using the " Temp/heating" key. Now you can pro-
gramme the capacity required by means of the
arrow keys, 3500W being the highest and 100W
the lowest position.
• If you select temperature control, select "Temp"
using the "Temp/heating" key. Now you can pro-
gramme the required temperature by means of
the arrow keys between 35°C and 240°C in 5°C
intervals.
• After programming the capacity or temperature,
you can opt to programme the timer. This timer
switches the appliance off after the programmed
time has been reached. You do this by pressing
GB
7