Door Reversibility - ZANKER ZKK 8417 K Gebrauchsanweisung

The Manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the following
E.E.C. Directives:
- 87/308 EEC of 2/6/87 relative to radio interference
suppression.
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.

Door reversibility

The side at which the door opens can be
changed from the right side (factory
adjustment) to the left side, if the installation
site requires. To change the opening direction
of the door proceed as in the following
instructions before installing it.
Warning! When changing the side at which
the door opens, the appliance may not be
connected to the mains.
Remove plug from the mains beforehand.
1. Unscrew the upper pin and remove the
spacer.
2. Remove the upper pin and the upper door.
3. Unscrew the middle hinge und the covers on
the opposite side.
4. Remove the lower door.
5. Unscrew the lower pin and refit it on the
opposite side.
6. Refit the lower door.
7. Rescrew the middle hinge und the covers on
the opposite side.
8. Refit the upper door and rescrew the hinge
pin and the spacer on the opposite side
Instructions for totally built-in appliances
Building-in instructions
Dimensions of housing
Height 1580 mm
Depth 550 mm
Width 560 mm
For safety reasons, minimum ventilation must be as
shown in Fig.
Attention: keep ventilation openings clear of
obstruction.
40
ATTENTION!
It must be possible to disconnect the appliance from
the mains power supply; the plug must therefore be
easily accessible after installation.
50 mm
200 cm
D567
min.
2
min.
200 cm
2