Atag VA63313LT/A01 Benutzerinformation Seite 18

18
Problem and alarm code
The appliance does not fill with water.
• The end indicator flashes 1 time in‐
termittently.
• Acoustic signal sounds 1 time inter‐
mittently.
The appliance does not drain the wa‐
ter.
• The end indicator flashes 2 times
intermittently.
• Acoustic signal sounds 2 times in‐
termittently.
The anti-flood device is on.
• The end indicator flashes 3 times
intermittently.
• Acoustic signal sounds 3 times in‐
termittently.
The appliance stops and starts more
times during operation.
The program lasts too long.
Small leak from the appliance door.
The appliance door is difficult to close.
Rattling/knocking sounds from inside
the appliance.
The appliance trips the circuit-beaker.
Possible cause and solution
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply
is not too low. For this information, contact your
local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not
clogged.
• Make sure that the inlet hose has no kinks or
bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or
bends.
• Close the water tap and contact an Authorised
Service Centre.
• It is normal. It provides optimal cleaning results
and energy savings.
• If the delayed start option is set, cancel the de‐
lay setting or wait for the end of the countdown.
• The appliance is not levelled. Loosen or tighten
the adjustable feet (if applicable).
• The appliance door is not centred on the tub.
Adjust the rear foot (if applicable).
• The appliance is not levelled. Loosen or tighten
the adjustable feet (if applicable).
• Parts of the tableware are protruding from the
baskets.
• The tableware is not properly arranged in the
baskets. Refer to basket loading leaflet.
• Make sure that the spray arms can rotate freely.
• The amperage is insufficient to supply simulta‐
neously all the appliances in use. Check the
socket amperage and the capacity of the meter
or turn off one of the appliances in use.
• Internal electrical fault of the appliance. Contact
an Authorised Service Centre.