Dmx Operation - EuroLite LED IP Tourlight 120 QCL Spot Bedienungsanleitung

DMX operation

Functions in DMX mode
Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 9 control channels.
However, it can also be switched to a mode with 1, 4 or 8 channels if different functions are required. To be
able to operate the device with a DMX controller, the DMX starting address must be set. The starting
address depends upon which DMX controller is being used. Please refer to the controller's documentation.
1 Press the MODE button so many times until "ADDR" is indicated on the display. Confirm with the
ENTER button.
2 Set the address via the UP and DOWN buttons and confirm with ENTER.
3 Press the MODE button and then press the "DMX mode" on the display is indicated CH:01 (1 DMX
channel), CH:04 (4 DMX channels), CH:08 (8 DMX channels) or CH:09 (9 DMX channels). Use the
buttons UP and DOWN to select the desired number of DMX channels. Confirm with the ENTER button.
4 The display will not blink when DMX signals are being received. If no control signals are available, the
display will blink.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed
similarly, they will work synchronically.
Functions in DMX mode
1-Channel Mode
Channel
Color Macros
4-Channel Mode
Channel
1
2
3
4
Value Function
000 - 000 Blackout
000 – 255 Macro selection
Value Function
000 – 255 Red (0 – 100%)
000 – 255 Green (0 – 100%)
000 – 255 Blue (0 – 100%)
000 – 255 White (0 – 100%)
28/32 00123151, Version 1.0