Items Supplied; Proper Use - EINHELL TE-MS 254 T Originalbetriebsanleitung

22. Locking grip for miter angle
23. Scale (miter)
24. Pointer (miter)
25. Adjustment screw for angle stop 90°
26. Adjustment screw for angle stop 45°
27. Lock nut for angle stop
28. Extractor socket for crosscut mode
29. Extractor adapter
30. Laser
31. On/Off switch for laser
32. Motor unit
33. Retaining pin for machine head
34. Stop screw
35. Latching pin for motor unit
36. Stop screw
37. Saw table for table mode
38. On/Off switch for table mode
39. Blade guard for table mode
40. Splitter
41. Socket head screw for splitter
42. Table insert for table mode
43. Parallel stop
44. Clamp lever
45. Scale for parallel stop
46. Push stick
47. Extractor socket for table mode
48. Tilt guard
49. Hex key 5/6 mm
50. Face spanner

2.2 Items supplied

Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
Anl_TE-MS_254_T_SPK13.indb 28
GB
swallowing or suff ocating!
•
Crosscut and miter saw with table
•
Blade
•
Locking screw for turntable
•
Workpiece supports (2x)
•
Clamping device
•
Extractor adapter
•
Splitter together with blade guard
•
Parallel stop
•
Push stick
•
Hex key 5/6 mm
•
Face spanner
•
Original operating instructions
•
Safety instructions

3. Proper use

The crosscut and miter saw with table is designed
for crosscutting wood and wood-type materials
which are appropriate for the machine's size
(crosscut mode).
In addition you can also use this saw to make lon-
gitudinal cuts in all types of timber commensurate
with the machine's size (table mode).
You are not allowed to use the saw to make cuts
in any type of round timber. The saw is not desig-
ned for cutting fi rewood.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
Only blades suitable for the saw are allowed to be
used. It is prohibited to use any type of cutting-off
wheel.
To use the saw properly you must also observe
the safety information, the assembly instructions
and the operating instructions to be found in this
manual.
All persons who operate and service the machine
must be acquainted with these instructions and
must be informed about potential hazards. It is
also imperative to observe the accident preven-
- 28 -
10.05.2023 15:03:52