whisker litter-robot 3 Bedienungsanleitung Seite 9

The Litter-Robot litter sifting system requires clumping litter to work properly. We
recommend a high-quality, clay-clumping litter. Use of lightweight litters, such as corn
or wheat, may require more weight to activate the Cat Sensor. Litter beads and crystals
that are small enough to pass through the screen will also work (periodic changing of
this type of litter is required).
DO NOT use litters that are the strictly absorbent, non-clumping, loose-clumping, news-
paper-based, or wood-based pellets.
If you are using a litter alternative not listed here, please contact Customer Experience
to make sure you are using a compatible litter.
Tip: When filling the Litter-Robot for the first time, it is best to continue using the brand
of litter you were using previously—as long as it is a clumping type of litter. Your cat will
need to adjust to the new litter box, and introducing a new litter at the same time may
increase his anxiety. However, if you are currently using a non-clumping litter, you will
need to switch to a clumping type.
Power and Initial Clean Cycle
Plug the small end of the Power Supply into the
power input at the back of the Base. Then plug
the AC/DC adapter into a wall outlet.
Locate and press the Power button. The Litter-Robot
will perform an initial Clean cycle that will last about 2
minutes. Learn more about the Clean cycle on page 12.
Congratulations!
Your Litter-Robot is now ready to use; however, we recommend powering the unit off
until your cat/s become familiar with and begin using the Litter-Robot.
9
whiskersupport.com
Power Input