Wait Time Setting; Control Panel Lockout; Optional Backup Battery - whisker litter-robot 3 Bedienungsanleitung

Wait Time Setting

The Wait Time is the elapsed time starting from when your cat exits the Globe until the
unit starts a Clean cycle. It can be set for 3, 7, or 15 minutes. The default Wait Time is 7
minutes.
Reduce the Wait Time if it is important to minimize odor and/or the time that waste is
available to other pets—such as dogs. However, reducing the Wait Time may reduce
the cleaning effectiveness if clumps do not have enough time to set up. Extend the Wait
Time when using a lower-quality clumping litter that needs more time to set up.
Press and hold the Empty button for about 5 seconds to enter Wait Time Setting mode.
One of the lights will start flashing, indicating the current Wait Time Setting. Use the
Reset button to toggle to the next setting: blue for 3 minutes, yellow for 7 minutes, and
red for 15 minutes. Press and hold the Empty button to save the setting. The blue light
will blink to confirm, then return to standby.

Control Panel Lockout

Control Panel Lockout disables button functions to prevent unwanted changes.
The Litter-Robot functions normally in Automatic Mode during Control Panel Lockout.
Press and hold the Reset button for about 5 seconds to enter or exit Control Panel
Lockout. The blue light will blink to confirm status.
While in Control Panel Lockout, you can still turn the unit off by pressing and holding
the Power button for 3 seconds.

Optional Backup Battery

The Litter-Robot has the option of a Backup Battery. Using a sealed 12VDC, 1.3 Amp
Hour battery allows the unit to continue working during power outages. When power to
the Litter-Robot is interrupted, the unit automatically switches to Backup Battery power,
indicated by the Power button becoming backlit by a yellow light.
Note: The Night Light function will be disabled during Backup Battery mode to conserve
energy.
24
whiskersupport.com