Empty Button - whisker litter-robot 3 Bedienungsanleitung

16
Empty Button + [Wait Time Setting]

Empty Button

Press and Release: Starts an Empty cycle (see page 13), which empties all litter from
the Globe into the Waste Drawer for easy disposal. During the Empty cycle, the Globe
will rotate clockwise, then stop with the yellow light on and await your action. Press any
button to return the Globe to the Home position.
To pause the Empty cycle, press any button. Press Cycle to resume the Empty cycle or
Empty or Reset to abort the cycle and return the Globe to the Home position.
IMPORTANT: Supervise and prevent your cat from entering during the Empty Cycle, as
the unit may not detect your cat without litter in it.
Press and Hold: Enters Wait Time Setting mode (see page 24). One of the lights will
start flashing, indicating the current Wait Time Setting. Use the Reset button to toggle
to the next setting: blue for 3 minutes, yellow for 7 minutes, and red for 15 minutes.
Press and hold the Empty button to save the setting. The blue light will blink to confirm,
then return to standby.
The Wait Time is the time that elapses starting from when a cat exits the Globe until the
unit performs a Clean cycle.
It may be useful to reduce the Wait Time to minimize odor and/or the time that the
waste is available to other pets—such as dogs. However, reducing the Wait Time may
reduce the cleaning effectiveness if clumps do not have enough time to set up. Extend
the Wait Time when using a lower-quality clumping litter that needs more time to set up.
whiskersupport.com