Control Panel - Indicator Lights - whisker litter-robot 3 Bedienungsanleitung

Control Panel - Indicator Lights

Blue Light On: OK/Standby
The unit is OK and ready for your cat's next use.
Blue Light Flashing: Waste Drawer is Full
The Waste Drawer is approaching full (see page 21). Remove the waste, install a new
liner, then press Reset to cancel the flashing light and adjust the Cat Sensor.
Blue and Yellow Lights On: Sleep Mode
The Litter-Robot is in 8-Hour Sleep Mode (see page 23).
Yellow Light On: Cycling/In Use
The Litter-Robot is cycling (Clean or Empty cycle).
Yellow Light Flashing: Cycle Interrupted
A yellow light flashing slowly (about once per second) indicates a cycle has been
interrupted by one of the following:
●
While cycling, if the Cat Sensor is activated by a cat entering the Globe, the unit
will stop and the yellow light will flash. The unit will start to cycle again 15 seconds
after your cat has left the Globe.
●
If the Bonnet is removed while cycling or while the Globe is at the Home position,
the unit will stop (if previously cycling) and the yellow light will flash. The unit will
resume its previous function 5 seconds after the Bonnet is replaced (see page
28-29).
A yellow light flashing quickly (about four times per second) indicates a cycle has been
interrupted by the Anti-Pinch Safety Feature (see page 30). While cycling, if a potential
pinch condition is detected, the Globe will stop and reverse direction for 2 seconds.
The yellow light will begin flashing quickly, awaiting your action. Once the blockage is
cleared, press any button to return the Globe to the Home position.
18
whiskersupport.com