whisker litter-robot 3 Bedienungsanleitung Seite 34

34
How much litter do I put in the Litter-Robot?
Fill the Globe with approximately 3.6-4.5 kg of litter, until it meets the raised Fill Line on
the black rubber Globe liner when spread flat. If there is too much litter in the Globe,
it will be expelled into the Waste Drawer during the first few cycles. Since the waste
clumps are removed during each cycle, there is no need to put excessive litter in the
Globe.
How often do I need to add litter?
The Litter-Robot uses litter very efficiently since the patented sifting system only re-
moves the clumps. We recommend checking the litter level against the raised Fill Line
(on the black rubber liner of the Globe) each time you empty the Waste Drawer, which
is about once per week for a single cat or twice for multiple cats. Be careful not to over-
fill the Globe.
Is dust a problem with the frequent rotation of the Globe and the movement of the
litter?
No, any dust is negligible since the Globe rotates very slowly.
How often do I need to empty the Waste Drawer?
This depends on the number and size of your cats. For two average-sized cats, twice
per week is typical. For a single cat, once per week is usually sufficient.
How often do I have to clean the inside of the Globe?
This depends on your personal preference and your cat's behavior. We recommend
cleaning the inside of the Globe every one to three months. See Use and Care on page
25.
How do I clean the Litter-Robot exterior?
Cleaning the Litter-Robot exterior is easy. Just remove the Globe and the Drawer and
give them a sponge bath, or take them outside for deep cleaning with the garden hose.
All other surfaces can be wiped clean, but should not be submerged.
CAUTION: The Base and Bonnet of the Litter-Robot contain electrical components
that should not be submerged. See Use and Care, page 25.
whiskersupport.com