whisker litter-robot 3 Bedienungsanleitung Seite 12

Clean Cycle
After your cat leaves the Globe, the Litter-Robot automatically performs a Clean cycle.
The patented sifting system separates the clumps from the clean litter and deposits
them into the Waste Drawer below. It takes about 2 minutes. You can also press the
Cycle button to start a Clean cycle.
During a Clean cycle, press any button to pause the cycle. Press the Cycle button to
resume the cycle. Press the Reset or Empty button to abort the cycle and return the
Globe to the Home position.
How it works:
The Litter-Robot is ready for use when the Globe is at the Home position and the blue
light on the Control Panel is on.
1.
When a cat enters the Globe, the Cat Sensor is activated; the blue light turns off
and the red light turns on.
2.
Once the cat exits the Globe, the countdown to a Clean cycle begins. When the
Wait Time (see page 24) has elapsed, the red light turns off and the yellow light
turns on as a Clean cycle begins.
3.
The Globe rotates counterclockwise. The yellow light will be on while cycling.
4.
During rotation, a weight behind the black rubber Globe liner causes the liner to
fall away from the Globe to ensure any stuck-on clumps are removed.
5.
The screen passes through the litter, separating the clumps from the clean litter.
The clean litter is collected in a chamber behind the screen.
6.
As the Globe rotates to Dump position, the waste clumps fall through the Waste
Port in the Waste Drawer.
7.
The Globe then rotates clockwise, toward the Home position. The Globe liner will
fall back into place and the clean litter will spill back into the litter bed.
8.
The Globe will rotate past the Home position to level the litter before finally re-
turning to the Home position. The yellow light turns off and the blue standby light
turns on.
12
whiskersupport.com