Ongoing Maintenance - whisker litter-robot 3 Bedienungsanleitung

11

Ongoing Maintenance

Empty the Waste Drawer when indicated by the flashing blue light on the Control
Panel.
How often you will need to empty the Waste Drawer depends on the number and size
of your cats. For two average-sized cats, twice per week is typical. For a single cat,
once per week is usually sufficient.
Pull out the Waste Drawer using the handle below the step, then gather the edges of
the liner bag and dispose.
You can use Litter-Robot custom-fit, biodegradable Waste Drawer Liners or any
38-49-liter trash bags.
To install a new drawer liner, open the bag and roll down the edge about four times.
Starting at the back of the drawer, push the rolled edge of the bag into each of the four
tabs, keeping the bag taut as you work forward. Slide the drawer back in, being careful
not to push the unit against the wall or into a corner (must not be touching any walls).
Then, press the Reset button to reset the Cat Sensor.
Add litter as needed.
Check the litter level once per week or each time you empty the Waste Drawer. Add
just enough litter to meet the raised Fill Line inside the Globe, and be careful not to
overfill it. After adding or removing litter, press the Reset button to reset the Cat Sensor.
Press the Reset button.
Any time you affect the weight or placement of the unit (including emptying the Waste
Drawer, adding or removing litter, or cleaning or moving the unit), press the Reset but-
ton to ensure the Cat Sensor will detect your cat and cycle properly.
See Use and Care on page 25 to learn about the Carbon Filter, Base Seal Strips, Waste
Drawer Liners, and how to clean the Litter-Robot.
whiskersupport.com