Drawer Full Indicator; Automatic Night Light - whisker litter-robot 3 Bedienungsanleitung

The Reset button is another way to reset the Cat Sensor after doing anything that
affects the unit's weight. Press Reset firmly and quickly, then watch for the blue light to
flash to confirm you have reset the Cat Sensor. Be careful not to rest on the unit as you
press the button or your weight will influence the reading.
Drawer Full Indicator (DFI)
The Litter-Robot is equipped with infrared emitters
and sensors located above the Waste Drawer that
check if the drawer is full each time the Globe returns
to the Home position. The Control Panel displays a
flashing blue light when the DFI is activated. Upon the
first activation of the DFI, the blue light flashes, and
the Cat Sensor remains active. Upon the third activa-
tion of the DFI (after two more Clean cycles), the Cat
Sensor deactivates and the unit will no longer cycle
automatically. Check or empty the Waste Drawer,
then press Reset to cancel the indicator and reset
the Cat Sensor.

Automatic Night Light

Although cats generally have excellent vision, aging and illness can diminish their ability
to see in low light conditions. The Automatic Night Light, located in the upper Bonnet,
is there to help guide your cat to the litter box. A light sensor located above the Cycle
button turns the Night Light on and off automatically. Turn the Night Light function on
and off by pressing and holding the Power button (see Control Panel - Buttons section,
Power Button, page 14).
21
whiskersupport.com
Drawer Full Indicators