Channel Monitoring - Emerson CSI 6500 Machinery Health Monitor A6110 Schnellstartanleitung

Product Information / Produktinformation A6110
Shaft Vibration Monitor
Signal outputs EO 1 / EO 2
d14 / d16
voltage output 0 ... 10V. For modes with separate channels according to the characteristic
value. For modes S
Measuring range and evaluation according to the characteristic value.
Depending on the application and configuration the outputs EO can be used for linkage or for
display.
Open circuit and short circuit proof, non reactive.
Nominal range
Resolution
Per. load resistance
Internal resistance
Signal inputs EI1 / EI2
Inputs for single−channel measurement values 1 ... +10 V for connection with EO outputs.
Voltage input EI1 / EI2
Nominal voltage range
Resolution
Input resistance
Signal input KEY
The key pulse is required for internal RPM determination for checking the measurements in
the measured value analysis.
Signal input KEY (N)
Signal level
Input resistance

1.6.2 Channel monitoring

Monitoring function
Sensor signals
GOOD thresholds
− Lower threshold value
− Upper threshold value
System voltages
and S outputs of the single−channel measured values.
max PPmax
0 ... +10 V DC
8−bit
> 10 kΩ
Approximately 50 Ω
b14 / b16
0 ... +10 V DC
10−bit
> 100 kΩ
d22
24 V logic,: LOW = 0 ... 3 V; HIGH = 13 ... 48 V
> 10 kΩ
Constant monitoring
GOOD range (configuration dependent)
Sensor work range lower value −0.5 V
Sensor work range upper value +0.5 V
Voltage − OK
Page 16