Emerson CSI 6500 Machinery Health Monitor A6110 Schnellstartanleitung Seite 15

Product Information / Produktinformation A6110
Shaft Vibration Monitor
Signal conditioning for characteristic values
The input signals are conditioned by adjusting amplifier, range−dependent amplifier, high
pass, and low pass prior to digitalization.
Range setting
Minimum measuring range
Maximum measuring range
Frequency range
High pass filter
− Parameters can be set
− Tolerance
Low pass filter
Characteristic value formation
2−channel operation
Maximum deflection S
max
accordance with DIN 45670
characteristic value A
Maximum vibration amplitude S
accordance with
DIN 45670 characteristic value B
Max (X,Y)
in accordance with API 670
Current outputs−characteristic values
Characteristic value formation and evaluation depends on the functions specified in the
configuration.
Current output 1 − I1+ / I1−
Current output 2 − I2+ / I2−
Nominal range
−Life zero operation
Precision / resolution
Per. load resistance
Is determined in the configuration
400 mVpp
8000 mVpp
Butterworth filter 2
fu 0.5 Hz (−3 dB) for work frequency 1 Hz
fu 2 Hz (−3 dB) for work frequency 5 Hz
±20 %
Butterworth filter 5
Parameter range 50 Hz ... 2000 Hz in 0.01 Hz
increments
Depends on the configuration
S1 and S2 separated characteristic values, optionally
in 0−P or S−S evaluation.
in S = max sk (t);
max
sk(t) + s
1
in
ppm
S = (S 1, S
ppm pp
S = Max (s
ppm
z18 / b18 (0 V / common)
z20 / b20 (0 V / common)
0 ... 20 mA or 4 ... 20 mA, depending on the
configuration
in 4 ... 20 mA operation you can specify via the
configuration that the output is set to 0 mA if a fault is
detected.
±1 % of f.s.d. / 16 Bit
500 Ω
nd
order
nd
order
(t) 2 ) s (t) 2
2
2) Max
pp
1 or s 2 )
p−p p−p
Page 15