Operator Manual; Installation; Gas Connection; Gas Pressure - CombiSteel 7455.0976 Gebrauchsanweisung

3.2 OPERATOR MANUAL

This manual contains important information for your safety and the installation, operation, maintenance and
service of this equipment. Please read the manual carefully and ensure all operators of the equipment are aware
of the contents and safety requirements.
Warning: You must assess all hazards and risks associated with the operation of the equipment in your
environment and advise all operators of them.

3.3 INSTALLATION

This equipment must be installed by an authorized person in accordance with local authority, gas, electricity, and
any applicable statutory regulations and manufacturer requirements.

3.4 GAS CONNECTION

The appliance must be connected by an authorized person to the gas type specified on the unit. The gas type is
shown adjacent to the gas connection point on the rear panel and on the data plate. Connect to and use only
the correct type of gas.

3.5 GAS PRESSURE

The authorized person installing this equipment must ensure that the gas operating pressure is the same as
shown on the data plate and that there is sufficient gas volume.

3.6 COMMISSIONING

The authorized person installing this equipment must commission the equipment in accordance with local gas
safety regulations - gas leakage, operational checking, adjustments and instructing the owner on use of the
equipment are prescribed requirements.

4. SPECIFICATIONS

4.1 INSTALLATION
THIS EQUIPMENT MUST BE INSTALLED BY AN AUTHORIZED PERSON IN ACCORDANCE
WITH LOCAL AUTHORITY, GAS, ELECTRICITY, ANY APPLICABLE STATUTORY
REGULATIONS AND MANUFACTURER REQUIREMENTS.
NOTE: INSTALLATION IS THE RESPONSIBILITY OF THE OWNER
Gas Inlet Connection:
Gas Connection Point:
Gas Connection:
The authorized person installing this equipment must comply with local gas safety standard. Prescribed
requirements include, commission the equipment, gas leakage testing, operational checking and adjustments.
All units are tested and adjusted at the factory; however, all burners and pilots must be checked at the installed
location and adjusted as necessary.
1/2" BSP Female.
The gas connection point is located at the rear of the unit.
Details are shown in the drawings at the rear of this manual.
The appliance must be connected by an authorized person to the gas type specified
on the unit. The gas type is shown adjacent to the gas connection point on the rear
panel and on the data plate. Connect to and use only the correct type of gas.
www.combisteel.com
6