Settings; Language; Release Code; Cloud Service - Helios KWL 360 W Montage- Und Betriebsvorschrift

Installation and Operating Instructions
EN
Central ventilation unit – KWL 360 W/W ET

7.2.4 Settings

7.2.4.1 Language

Select the desired language for the user interface.

7.2.4.2 Release code

Change release code.
ⓘ The release code is pre-set to 0000 as standard.

7.2.4.3 Cloud service

Connect unit to the easyControls cloud service or disconnect cloud service. When connecting to the cloud service, the
homepage will open automatically for logging on.

7.2.4.4 User level

3 user levels are available:
• Admin: The user has full access to all unit settings.
• Normal: The user can see the ventilation unit data and change some settings. Access to special settings is blocked.
• Restricted: The user can change the ventilation mode and see unit data. However, the user cannot edit any system
settings.

7.2.4.5 Child-proof lock

The control element KWL-BE Touch can be locked by assigning a PIN code with the child-proof lock.

7.2.4.6 Licence

The licence conditions can be called up here.

7.2.5 Configuration

7.2.5.1 Fan setting

Set fan power for supply and extract air fans.
• Supply air
• Extract air
ⓘ The fan powers may only be changed during adjustment!

7.2.5.2 Sensor settings

Set the connected sensor parameters:
• Temperature control depending on
• Supply air
• Extract air
The set supply air temperature changes depending on the extract air temperature (up to ±10 °C).
• Extract air Plus
The set supply air temperature changes depending on the extract air temperature (up to ±10 °C). The ventilation
unit increases the power if there is the possibility to reduce the room temperature with the intake air.
• Rel. humidity
• Automatic
ⓘ The limit values are automatically determined using the recent humidity curve.
• Manual
• %RH limit
• CO2/VOC limit

7.2.5.3 Heat exchanger frost protection

Setting the boundary conditions for frost protection:
• Passivhaus
ⓘ Mandatory selection for Passivhaus.
• DiBt

7.2.5.4 Modbus settings

The following parameters can be adjusted:
• Address
• Baud rate
• Parity
• Stop bit

7.2.5.5 Input settings

View or edit input settings:
• Analogue input
• Not used
• Stop (0-1 V), Away from home (2-4 V), At home (5-7 V), Intensive ventilation (8-10 V)
• Digital input 1 / Digital input 2
• Not used
• Fireplace mode Off / On (0 V / 24 V)
• At home / Away from home (0 V / 24 V)
• Emergency off/Normal mode (0 V / 24 V)
• Intensive ventilation Off/On (0 V / 24 V)
25