Initial Commissioning; Run Commissioning Assistant - Helios KWL 360 W Montage- Und Betriebsvorschrift

Installation and Operating Instructions
CHAPTER 6
COMMISSIONING
Central ventilation unit – KWL 360 W/W ET
6.1

Initial commissioning

The unit must be properly connected or linked to the mains power supply for the initial commissioning. The commissio-
ning assistant can then run via the local web server or optionally via the control element KWL-BE Touch (accessories).
• Initial commissioning via local web server
– Set up local web server, see chapter 7.1.1 „Local web server", page 22.
– Run commissioning assistant, see chapter 6.2 „Run commissioning assistant".
• Initial commissioning via control element KWL-BE Touch (accessories)
Installation and commissioning see Installation and Operating Instructions KWL-BE Touch.
ⓘ The unit cannot operate without successfully completing the initial commissioning !
6.2

Run commissioning assistant

ⓘ I n order to run the commissioning assistant, the local web server of the KWL
mobile end device (see chapter 7.1.1 „Local web server", page 22).
1. Establish connection of the local web server (KWL
> The commissioning assistant starts automatically for the initial commissioning.
Otherwise, the unit must be reset to factory settings to start the commissioning assistant again.
2. Configure settings for language, time and date and click "Next".
> The settings for access rights are displayed.
ⓘ
Master code: 0000 (pre-set)
ⓘ
Function only available for control element KWL-BE Touch.
3. Configure settings for access rights and click "Next".
unit) to a mobile end device.
®
16
unit must be connected to a
®
Fig. 21
Fig. 22
EN