Tolerance Check For Target Weight - KERN CPB-N Serie Betriebsanleitung

Start tolerance check
 Determine the average piece weight (see chap. 8.1) or enter manually (see
chap. 8. 2).
 Place the load, wait until the acoustic signal sounds, depending on the settings
in the menu „F10" (see chap. 11.2, only for non-verified models).
Delete limit values:
 For all limit values enter „0" and confirm using the TARE button.

10.2 Tolerance check for target weight

Select target weight mode:
Keep pressed, the set mode will
appear
42
Check psc - Tolerance check for target item
number
Press
Check off – Tolerance check switched off
Press
Check net -: Tolerance check for target
weight
CPB-N / CPB-DM-BA-e-1831