Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Note: Manually activated transmitter call (following section) and automatic recep-
tion (transmitter tower is blinking) will be performed only if no other time zones
were programmed as DCF-time plus/minus one hour. This restriction protects your
battery.
Transmitter call:
Actuate the corrector 2 (right) for more than 3 seconds. The hands of your
watch move fast to 12:00 o'clock position and in normal cases remain exactly in this
position. Should this position not be reached exactly, please continue according to
following instructions "Positioning of the hands" first. In case of immediate exact
position of the hands hold the watch still (best of all take it from the wrist and lay
it on a flat sur face: no metal surface) to establish a secure connection – transmitter
tower is blinking – the LCD seconds display starts counting. After few minutes your
watch sets all current time information automatically and the transmitter call is
finished. To stop the transmitter call before the function is completed, actuate the
button (right) shortly. After that the stored time values will be displayed.
Note "Positioning of the hands":
The exact 12:00 o'clock position has not been reached. Actuate the corrector 1
(left) now. The LCD shows "H" (zero position of hour and minute hands). In this
position your watch prompts you to set the hands to the exact 12:00 o'clock posi-
tion through further actuation of the corrector 1 (left). Permanent pressure starts
20
a continuous fast movement of the hands, single actuation results in individual
steps. As soon as the correct position has been reached, finish the positioning
through a short actuation of the corrector 2 (right).
The LCD shows "S" (zero position of the second-sweep-hand).
In this position your watch prompts you to set the second-sweep-hand to the exact
12:00 o'clock position through further actuation of the corrector 1 (left).
Permanent pressure starts a continuous fast movement of the hands, single actua-
tion results in individual steps. As soon as the correct po sition has been reached,
finish the positioning through a short actuation of the corrector 2 (right).
Switching between the settings of the hours/minutes hands "H" and second-sweep-
hand "S" is possible as many times as you like. As soon as the correct position has
been reached, finish the positioning through actuation of the corrector 2 (right)
for more than 3 seconds. The watch switches to DCF reception mode. Display:
Transmitter tower is blinking.
Note to operate errors:
If you inadvertently actuate both control elements simultaneously for more than 3
seconds, a microprocessor in your watch performs a hardware reset, all saved time
information is lost. In this case follow the instruction for restart of your watch after
replacement of the battery.
21
Werbung
