Wifi Connection - Nibe CMO 22 Serviceanleitung

Wifi connection

Start the inverter; the LED for "Power" will
1.
flash twice.
2. Load the "SEMS Portal" app onto your smartphone
by scanning the code below:
3. Register an account in the app.
4. Click on "wifi configurations" on the app's home
page.
Connect to the wireless network "Solar - WiFi", enter
5.
the password 12345678 and click on "next"
6. Check that the inverter is running and click on "next".
7. Select your home network and then select "Go into
WLAN setting interface"
Log into your home network.
8.
When you see "Successful Configuration", click on
9.
OK.
10. The installation of wifi is now complete. Follow the
instructions in the app to connect the inverter. You
will need the serial number and the "checkcode",
which can be found on the label on the right-hand
side of the inverter. You can also snap the QR code
on the label with the SEMS portal app. When con-
necting for the first time, it can take 10-15 minutes
before the information is updated in the app. During
this time, the system may be displayed as "offline".
10
Troubleshooting
CANNOT FIND A WIFI SIGNAL OR THE
SOLAR WIFI NETWORK
• Check the cable connection to the communication
module
• Stand closer to the inverter
• Check that the inverter is running
• Restart the inverter and try again
• If it is dark outside, the solar panels may not be sup-
plying enough energy to power the inverter; try again
when it is light outside.
CANNOT CONNECT TO SOLAR WIFI?
• Check the password, 12345678. Make sure there are
no spaces, full stops or other characters before or
after the digits
• Restart the inverter
THE SYSTEM IS SHOWN AS OFFLINE
• When connecting for the first time, it can take 10-15
minutes before the system is displayed as online.
For more information, see the manual for the inverter
or visit Goodwe's wifi-guide at:
https://en.goodwe.com/Public/Home/Wi-Fi%20connec-
tion%20Guide.pdf
NIBE CMO 11/ CMO 22 | GB