Cleaning; Group Head And Rubber Seal; Accessories - Clatronic ES 3643 Bedienungsanleitung, Garantie

6. Briefly open the steam control knob (3) towards "+" every
time before using the frothing function to drain collected
condensate. The appliance is ready to use if only steam
escapes.
7. Place your milk jug with the milk under the steam nozzle.
8. Lift the jug so that the steam nozzle sits just under the
milk surface.
NOTE:
Do not place the steam nozzle in the centre of the jug
but close to the inner wall. This position is important
for the milk to get into whirling motion. We recommend
using the spout as guide for the steam nozzle.
9. Slowly open the steam control knob (3) towards "+" until
the desired amount of steam is set. Slightly move the jug
up and down. Close the steam control knob towards
"OFF" after the milk has frothed to the desired volume
(approx. 50 %).
NOTE:
• To further heat up the milk insert the steam nozzle
all the way to the bottom of the jug. Ensure that the
milk does not start boiling. In this case the foam will
collapse.
• The water is no longer hot enough if the indicator
lamp (11) turns off during frothing. Turn the steam
control knob towards "OFF". Wait until the indicator
lamp "ok" lights up again. Now continue frothing the
milk.
WARNING:
• Before cleaning, always remove the mains plug and wait until the
device has cooled down.
• Do not immerse the device in water. Otherwise this might result in
an electric shock or fire.
• The steam nozzle is hot immediately after use!
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• Clean the casing with a slightly damp cloth without
detergents.

Group Head and Rubber Seal

Wipe group head and rubber seal with a damp cloth. Use
a soft nylon brush to remove stubborn residues. Dry with a
soft cloth.
ES 3643_IM
10. To remove the last coarse air bubbles knock the milk jug
after frothing carefully on the tabletop (as if you would
set it down a bit hard). Swivel the milk jug slightly around.
This helps to mix the foam after frothing. Now waste no
time. Pour the frothed milk slowly into the espresso.
11. Swivel the milk jug slightly around while pouring the
frothed milk slowly into the espresso.
NOTE:
• With a few artful movements you can draw designs
into the foam.
• Sprinkle cocoa powder or cinnamon to taste on the
foam.
12. IMPORTANT: Clean the steam nozzle immediately after
every use! When closing the steam control knob a vac-
uum is created within seconds, which draws some milk
into the steam nozzle. Place your heat-resistant container
under the steam nozzle. Open the steam control knob
briefly for a shot of steam to flush milk residue out of the
steam nozzle. Wipe the steam nozzle with a damp cloth.
13. Turn off the steam function by setting the switch (10) to
the position "".

Cleaning

Accessories

Wash filter holder, filter inserts, drip tray grid, drip tray, meas-
uring spoon, water tank and steam nozzle cover in warm
sudsy water. Use a soft nylon brush, if necessary. Rinse with
clean water. Dry all parts with a soft cloth.
CAUTION:
These parts are not dishwasher-safe. Heat and aggressive
detergents can cause distortion and decolouration.
57
02.03.16