Cleaning The Steam Nozzle - Clatronic KEB 2656 DS Bedienungsanleitung, Garantie

5....-05-KEB 2656 DS Neu
Filling the water
1. Open the hinged water chamber lid. Pour in the desired amount of water. The
number of cups that can be filled can be read with the water level display on the
side of the appliance. Place the glass pot with the lid correctly on the hotplate.
2. Switch on the appliance with the ON/OFF key. The light display shows that
brewing has started.
These instructions apply both for the coffee machine and for the espresso maker.
Switch the appliance off before cleaning. Pull out the plug and leave the appliance
to cool. The filter holder, filter basket, pot, pot lid, overflow grid and the collecting
tray can be washed in the top tray of the dishwasher. Wipe the appliance with a
moist cloth. Never dip the appliance in water or in any other liquid.
Clean the brewing head of the espresso maker with a moist towel and remove the
coffee powder. If there is still water in the water container, leave the appliance to
cool, remove all the loose parts and empty the appliance by turning it over.
Clean the steam nozzle after each time it is used, otherwise the inside of the nozzle
will clog up and the milk on the outside will become hard and very hard to remove.
The front part can be removed for cleaning. If the nozzle is clogged, remove all the
milk remains with a sewing needle. After frothing the nozzle should be immediately
wiped with a moist cloth. Hold the cloth close to the steam opening and turn the
steam control button. Steam the cloth for 1 – 2 seconds. The milk remains are
hence expelled. Switch off the appliance.
Attention: never open the appliance.
Both appliances are to be decalcified on a regular basis. The interval depends on
the hardness of the water and the frequency of use. Before decalcifying the espres-
so maker, the brewing sieve on the brewing head must be removed by unscrewing
the two screws on the brewing sieve with a cross screwdriver. Tip: these screws are
easier to reach when the appliance is tilted to the back. Make sure there is no water
in the appliance.
Clear signs are:
The machine is louder than usual.
The machine takes longer than usual.
If the appliance is used regularly, decalcify as follows:
Use only a commercial decalcifier. Dose it as prescribed on the package or in the
instructions and put it into the water container.
08.09.2003 9:30 Uhr
Cleaning

Cleaning the steam nozzle

Decalcifying the appliance
Seite 57
GB
57