Remote Control - Qlima Diandra 50 S-line Gebrauchsanweisung

DIFFERENTIAL TEMPERATURE
The differential temperature is the difference in degrees Celsius in relation to the
set temperature. Example: The set temperature is 20ºC and the set differential
temperature is 2ºC. The stove will now go out at a room temperature of 22ºC and
start up again at a temperature of 18ºC.
SWITCHING OFF SAVE MODE
1.
2.
3.
To prevent excessive start-ups and shut-downs and extra wear on various parts, it
is recommended not to set the differential temperature at less than 2ºC or higher
than 4ºC.
4.7 STANDARD SHUT-DOWN
The stove can be switched off by pressing button 3 until "OFF" appears in the dis-
play. During the shutdown phase, the supply of wood pellets to the combustion
chamber is stopped and the room air circulation blower is switched off. The smoke
extraction blower will continue to run for a short time, switching off after the
cooling-down phase.

4.8 REMOTE CONTROL

How to use the remote control:
1.
2.
3.
ECONO SEND
TURBO
ECONO SEND
ON 1 AUTO
OFF 1
TURBO
ON 2 CANCEL OFF 2
AUTO
ON 1 OFF 1
CANCEL
ON 2 OFF 2
ECONO
TURBO
ON 1
ON 2
ECONO SEND
TURBO
ON 1 AUTO
4
ON 2 CANCEL
156
Switch the stove off and repeat the above actions until "OFF" appears in the
display.
Then push button 3.
Save mode is now switched off.
Point the remote control at the stove's control panel.
Check that there are no obstacles between the remote control and the sig-
nal sensor on the stove.
Each mode that can be selected using the remote control must be confirmed
button. An acoustic signal will sound after each selection to
with the
ECONO SEND
TURBO
confirm the selected option.
ON 1 AUTO
OFF 1
ON 2 CANCEL OFF 2
ON/OFF: Use this mode to switch the stove and the remote control on or off.
Hold the button down for at least 2 seconds to switch the system on or off.
Press to confirm.
ECONO SEND
TURBO
ON 1 AUTO OFF 1
UP / DOWN: Use these buttons to set the desired temperature. The tempera-
ON 2 CANCEL OFF 2
ture can be set between 7ºC and 40ºC.
FAN: Select the desired speed
SEND
A = Automatic mode
Speed 1 (on1)
AUTO Speed 2 (on2)
OFF 1
Speed 3 (on3)
CANCEL
OFF 2
Speed 4 (on4)
Speed 5 (on5)
SEND: Use this button to confirm the selected mode and send it to the stove.
OFF 1
OFF 2