Information On The Diagnostic Scale - Sanitas sbg 39 Gebrauchsanleitung

General notes
• The unit is for personal use only and is not intended for medical or commercial applications.
• Please note that technically related measuring tolerances are possible, as the scale is not calibra-
ted for professional medical applications.
• The scale can accept a maximum load of 150 kg (330 lb, 24 St). The weight measurement and the
deter m ined bone mass are displayed in increments of 100 g (0.2 lb, 1/4 St), as is the specification
of the ideal weight. The measuring results for the body fat, body water and muscle percentages
are displayed in 0.1 % increments. The caloric requirements is specified in steps of 1 kcal.
• On delivery, the scale is set to "cm" and "kg". At the back of the scales is a switch with which you
can switch between "inches", "pounds" and "stones" (lb, st.).
• Place the scale on a firm level floor; a firm floor covering is required for correct measurement.
• The scale should be cleaned occasionally with a damp cloth. Do not use abrasive detergents and
never immerse the scale in water.
• Protect the scale against hard knocks, moisture, dust, chemicals, major temperature fluctuations
and heat sources which are too close (stove, heating radiators).
• Repairs may only be carried out by Beurer customer service or authorized dealers. Before submit-
ting any complaint, first check the batteries and replace them if necessary.
• All scales comply with EC Directive 2004/108 + supplements. Should you have any questions con-
cerning the use of our scale, please contact your dealer or customer service.
3. Information on the diagnostic scale
the measuring principle of the diagnostic scale
This scale operates according to the B.I.A. principle (bioelectric impedance analysis). This enables
physical relationships to be measured within seconds by means of an undetectable, completely
harmless electric current. The body fat percentage and other physical relationships in the body can
be determined by measuring the electrical resistance (impedance), and the inclusion in a calculation
of constants and individual parameters (age, height, gender, degree of activity).
Muscle tissue and water have good electrical conductivity, and therefore lower resistance.
Bones and fatty tissue, on the other hand, have low conductivity, as fat cells and bones conduct
h ardly any current as a result of their very high resistance.
Please be aware that values obtained from the diagnostic scale represent only an approximation of ac-
tual analytical medical data. Only a specialist physician can accurately determine body fat, body water,
muscle percentage and bone structure using medical procedures (e.g. computed tomography).
General tips
– If possible, always weigh yourself at the same time of day (preferably in the morning), after using
the toilet, on an empty stomach and unclothed, in order to achieve comparable results.
– Important for the measurement: body fat can only be measured when barefoot and with the soles
of the feet slightly moist. Completely dry soles can result in unsatisfactory measurements due to
in a dequate conductivity.
– Stand still during the measurement.
– Wait a few hours after unaccustomed strenuous activity.
– Wait approx. 15 minutes after getting up in the morning to allow the water in the body to distri-
bute.
limitations
When measuring body fat and other values, deviating and implausible results may occur in:
– children under approx. 10 years,
– competitive athletes and body builders,
– pregnant women,
– persons with fever, undergoing dialysis treatment or with symptoms of edema or osteoporosis,
10