Before Starting The Equipment; Cleaning, Maintenance And Ordering Of Spare Parts; Replacing The Power Cable - EINHELL TC-GG 30 Originalbetriebsanleitung

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
Only place the hot glue gun on non-fl ammable
surfaces.
Push the glue stick into the hot glue gun as for as
the stop. Now plug the mains plug into the mains
socket outlet. The hot glue gun is ready for use
after a heating time of approx. 5 minutes.
6. Operation
You can now apply the glue by pressing the trig-
ger.
Press both surfaces together immediately and
apply pressure. It takes about 30 seconds for the
glue to set.
Warning!
If your gluing work is interrupted or comple-
ted, always be sure to place the hot glue gun
on the support stand.
Important! Glue stains on textiles cannot be
removed.
Changing the nozzles (Fig. 3)
You can change the nozzles (1) to work better in
certain positions. Proceed as follows:
•
Pull the rubber cap (a) off the nozzle (1)
•
Remove the nozzle using a 13 mm wrench
(not included)
•
Check the seal (rubber ring) on the new nozz-
le for damage
•
Fit the new nozzle to the device and tighten it
•
Fit the rubber cap back onto the nozzle

7. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
Anleitung_TC_GG_30_SPK1.indb 15 Anleitung_TC_GG_30_SPK1.indb 15
GB
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering spare parts and accessories
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
Tip! For good results we
recommend high-quality ac-
cessories from
www.kwb.eu
welcome@kwb.eu
- 15 -
!
28.07.2016 11:13:29 28.07.2016 11:13:29