Hendi Hokker 147276 Bedienungsanleitung Seite 10

Extinguishing
1. Turn the control knob to the " " position.
2. Attention! After extinguishing wait ±10 minutes
before re-igniting the burner.
Cleaning and maintenance
• Let the appliance cool down before cleaning.
• Beware: Never immerse the appliance in water
or any other liquid!
• Clean the outside of the appliance with a damp
cloth (water with mild detergent).
• Clean the ventilation slots (if applicable) with a
vacuum cleaner.
Troubleshooting
If the appliance does not function properly, please check the below table for the solution.
EN
If you are unable to solve the problem, please contact the supplier / service provider.
Defects
Burner won't ignite
Burner will not ignite fully
Note
• It is recommended to replace the gas hose after
3 or 4 years (see date shown on hose). The gas
hose becomes porous after a time. Also check
the hose for leaks on a yearly basis at least. Even
if the expiration date has not been expired yet,
you must check the condition of the hose always.
In case of damage/cracks you have to replace
the hose immediately. Please make sure that you
comply with all local health and safety regula-
tions (e.g. firecode).
10
1 2
After extinguishing always close the main gas
valve!
• Keep inside after use.
• Let specialised personnel clean at least once a
year the burner.
• Never use a high pressure cleaner.
Possible causes
Ignition malfunction
Thermocouple malfunction
Dirty spark plug
Gas hose blocked
Injector blocked
Gas hose blocked
Gas valve not completely open
Injector blocked
Gas valve malfunction
• Pressure regulators have a default maximum life
span as indicated by the date printed on the regu-
lator, but please note that local health and safety
regulations may overrule this.
• Only replace the pressure regulator with one pro-
vided by the manufacturer.
• Consult the local regulations, these may differ.
• Always store gas bottles upright, in use as well
as when empty.