Battery; Spark Plug; Air Filter; Fuel System - Husqvarna LC 348VE Bedienungsanweisung

Battery

IMPORTANT! An exhausted battery must not be
disposed of as household garbage! Leave it at your
nearest service agent or collection point.
LC 353VE, LC 348VE
The battery is a totally enclosed 12 volt lead battery that
usually does not require maintenance. The battery is
charged during mowing.
If the engine refuses to start repeatedly, the battery could
become discharged. If that is the case, start the machine
manually using the starter cord. A completely discharged
battery can be recharged using the battery charger
supplied.
• Check all cables and connections. Never use the
machine if any cable or plug is damaged, but hand it
in to an authorized service workshop for repair.
Charging the battery
NOTICE! The battery might need recharging once or
twice during mowing season and should always be
charged prior to winter storage.
Do not charge at temperatures below +5° C.
• Disassemble the cable contact at the battery.
• Connect the battery cable to the charger, then
connect the charger to a wall socket (220 V, 50 Hz).
LC 353VI
The battery is a safety switch and must only be mounted
on the engine when the machine is in use.
The battery is an intelligent 10.8V lithium battery that
must be activated before being used for the first time.
Place the battery into the charger and wait until at least 1
green lamp comes on (10 seconds). The battery can then
be mounted on the engine.
IMPORTANT! The battery on this model is a safety
component. Always use genuine parts.
Charge the battery.
The battery has an easy-check voltage indicator with
LEDs (1-4).
If the voltage is too low (1 or 0 LEDs lit), place the battery
in the charger and connect to a wall socket (220V, 50Hz).
A flat battery will be fully charged after about 60 minutes.
88 – English
MAINTENANCE
The battery can be quick-charged for shorter periods
without damage.
Lamp indicator on
battery.
Constant red light
Flashing red light
Constant green light
Flashing red and
green light

Spark plug

NOTICE! Always use the recommended spark plug
type! Use of the wrong spark plug can damage the
piston/cylinder.
• If the machine is low on power, difficult to start or runs
poorly at idle speed: always check the spark plug first
before taking other steps.
• If the spark plug is dirty, clean it and check that the
electrode gap is 0.5 mm. Replace if necessary.
Air filter
• Remove the air filter cover and take out the filter.
• Clean the filter by knocking the filter against a flat
surface. Never use solvent with petroleum, for
example, kerosene, or compressed air to clean the
filter.
• An air filter that has been in use for a long time cannot
be cleaned completely. The filter must therefore be
replaced with a new one at regular intervals. A
damaged air filter must always be replaced.
• When reassembling, make sure that the filter
completely seals against the filter holder.

Fuel system

• Check that the fuel cap and its seal are not damaged.
• Check the fuel hose. Replace if necessary.

Recycling

This machine has the prerequisites to last for many years.
This minimizes the machine's environmental impact.
Perform service and maintenance according to the
instructions in this manual. This way the engine will last
longer and the hazardous emissions are minimized. The
machine is dismantled and the parts are divided up in
different materials for recycling. Most parts of this
machine are recyclable.
Cause
Battery charging.
Battery too warm and will start to
charge when correct
temperature has been reached.
The battery is fully charged.
Battery damaged and must be
replaced.