Husqvarna LC 348VE Bedienungsanweisung Seite 85

Drive
• To use the drive on the wheel pull the clutch lever
towards you.
When the drive starts feeling slow you need to adjust the
clutch wire. Finely adjust the wire using the adjuster
screw.
• To tension the wire and increase speed, screw the
adjustment screw counterclockwise.
Make sure the wires are not tensioned too tight. If the
lawn mower starts to drive withtout the clutch lever is
beeing operated, extend the wire.
• To extend the wire and reduce speed, screw the
adjustment screw clockwise.
OPERATING
Stopping
LB 348V, LC 348V, LC 348VE, LC 353V, LC 353VE,
LC353VI
• Stop the engine by releasing the engine brake bar/
start bar. The drive is also disengaged when you
release the engine brake bar/start bar.
IMPORTANT!
For LC 348VE and LC 353VE remove the key.
LC 353VI Always remove the battery when the machine
is not in use or when the machine is left unattended.
LC353VB
The cutter stops rotating when you release the brake
handle.
The engine is switched off by moving the stop switch to
the stop position.
–
English 85