Herunterladen Inhalt Inhalt Diese Seite drucken

Battery Charger; Control Panel - Husqvarna LB 442i Bedienungsanweisung

Vorschau ausblenden Andere Handbücher für LB 442i:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 89

Battery charger

LED on the battery
charger
The error LED flash-
es.
The error LED is on.

Control panel

Error code (Number
of flashes)
5
8
9
10
Other errors
Control panel
Error code (Number
of flashes)
1
5
8
9
10
Other errors
1520 - 004 -
Cause
The temperature in the work en-
vironment is too high or too low.
Possible faults
The motor speed decreases too much, and
the motor stops.
The battery is weak.
Battery error or no signal from battery.
The motor control is too hot.
If other errors occur, remove the safety key and the battery and speak to an approved
service agent.
Possible faults
The transmission motor is too hot.
The motor speed decreases too much, and
the motor stops.
The battery is weak.
Battery error or no signal from battery.
The motor control is too hot.
If other errors occur, remove the safety key and the battery and speak to an approved
service agent.
Solution
Use the battery charger in temperatures between 5°C
and 40°C.
Speak to an approved service agent.
Possible procedure
Clean the cutting deck and increase the cut-
ting height. Refer to
on page 17 . If the error stays, speak to your
approved service agent.
Charge the battery. Refer to
battery on page 17 .
Put the battery in the product correctly and
examine the battery connector. If the error
LED on the battery flashes, refer to
on page 17 .
Stop the motor and wait until it is cool.
Possible procedure
Let the product become cool. Make sure that
the transmission does not have grass on it.
Clean the transmission cover if it is necessa-
ry.
Clean the cutting deck and increase the cut-
ting height. Refer to
on page 17 . If the error stays, speak to your
approved service agent.
Charge the battery. Refer to
battery on page 17 .
Put the battery in the product correctly and
examine the battery connector. If the error
LED on the battery flashes, refer to
on page 17 .
Stop the motor and wait until it is cool.
To set the cutting height
To charge the
Battery
To set the cutting height
To charge the
Battery
21

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Lb 448i

Inhaltsverzeichnis