Instructions For Repositioning The Silencer Housings - FPZ SCL K07 MS Betriebsanleitung

4.1.4 INSTRUCTIONS
SILENCER HOUSINGS
Danger due
Impeller!
There may be a danger of shearing due to the impeller
rotating even when the machine is switched off, if it is
started manually.
Suitable working clothes and personal protective equipment
must therefore be used.
The SCL K-MS series is designed to provide maximum flexibility
in positioning the silencer housings, to allow for various
installation configurations.
The blower comes with the silencers positioned as shown in fig
1.
If this layout has to be modified, proceed to identify the layout of
the silencer housings required.
The possible solutions are shown in fig 2, fig 3, and fig 4 below.
fig 2
Fig.2
fig 2 with 90° manifold
90° manifold
Fig.2 con collettore 90°
_________________________________________________
fig 3
fig 3 with 90° manifolds
90° manifolds
Fig.3 con 2 collettori 90°
FOR REPOSITIONING
to rotating component s:
fig.1
Fig.3
THE fig 4
fig 4 with 90° manifold
90° manifold
_________________________________________________
Position the unit in a horizontal position with the feet on a flat,
stable surface.
Disassembling the silencer housing:
- Remove the bolts (908) and remove the flange (723) with the
O-Ring (426).
- Remove the bolts (906).
- Remove the silencer (700) with its gasket (424).
Fitting the blank flange (730):
- Remove the bolts (909) and the flange (730) with the O-Ring
(427).
427
730
909 162
Fit everything again in reverse order, not forgetting gaskets
424, 426, and 427.
USING THE (accessory) CK TYPE 90° MANIFOLD KIT
The 90° manifold can only be fitted for 162 cover o penings and
as shown in fig 2, fig 3, and fig 4 above there are a number of
installation configurations that are possible.
The CK type 90° manifold kit comprises:
N° 1 manifold
N° 1 gasket and
N° 4 M8x25 UNI 5739 bolts
To assemble the 90° manifold proceed as follows:
- Remove the silencer housing as described before.
- Put the gasket between the cover (162) and the 90° manifold,
and tighten the M8x25 UNI 5739 bolts.
- Assemble the silencer housing, following the instructions in
reverse order and not forgetting gasket 424 and 426.
GB - 22/64
Fig.4
Fig.4 con collettore 90°
424 906
723
426
700 908