XIONEER Vortex EZ Bedienungsanleitung Seite 7

•
Only connect the Vortex EZ to a 230 V AC, 50 Hz
power supply (unless specified otherwise on the
device). Be careful not to bend the cable or pull on
it when unplugging it. Do not use an extension
cord. The housing of the Vortex EZ is made of
metal, so please use a grounded AC-connection.
Only use provided power supply cables.
• Do not reach into the Vortex EZ tank while it is in
operation.
•
Always use the supplied basket for your parts. Only
lift and lower the basket using the handles.
•
Place the Vortex EZ out of reach of children. It may
only be operated by adults.
•
Do not use the Vortex EZ if you notice any damage
to its parts or if parts are missing.
•
Avoid spilling any liquids on the controls of the
device, fan plates, or plugs. Remove excessive
moisture with a soft cloth.
•
During operation the surfaces of the Vortex EZ
and the dyeing solution inside may become very
hot. Never reach into the hot bath with bare hands.
•
It is not allowed to prepare or store food inside the
Vortex EZ or with any parts of it. Dye and dyeing
additives are not suitable for consumption.
•
Only use water as solvent and only use TCN GTC
universal liquid dye, Nakoma Products Rit ProLine
or similar products as dyes. Do not fill more than
38 liters into the container ("MAX"). Observe the
recommended dosages when using the dyes or
dyeing additives.
Page 7