Propeller Maintenance - XIONEER Vortex EZ Bedienungsanleitung

with all additives BUT the dye and heat it up to 85
°C with the stirrer switched on for a few hours.
Follow the steps described before afterwards.
4. To remove scale, fill the Vortex EZ with 38 liters of
water. Add about 50 g of household citric acid.
Turn on the device, let it heat up to 60 °C. Allow the
citric acid to remove the scale for a few hours.
Empty the basin and rinse it well with water as
described before.
Caution: Make sure that there are no residues in
the tank the next time you use it. The residues
could interfere with the dye and change the
outcome of the dyeing process.

Propeller maintenance

The propeller and tank are equipped with strong
magnets. Pay attention to your surroundings
(credit cards, and especially pacemakers)!
When mounting or replacing the propeller, be
aware of the strong magnets pulling the propeller
down. Hold the propeller tightly while sliding it
slowly onto the pin. Do not let it drop because a
strong impact may damage the propeller's
bearing.
To remove deposits underneath the propeller, you can
remove the propeller. To do this, open the mounting
screw in the center of the propeller and lift the propeller
with the screw. After cleaning, mount the propeller back
onto the shaft. Tighten the screw ("hand-tight").
Page 17