Cleaning And Maintenance - XIONEER Vortex EZ Bedienungsanleitung

6. Now slowly open the valve. Check whether the
dyeing solution flows into the prepared container
and no spillage or dripping occurs outside.
7. When the Vortex EZ is almost empty, tilt it slightly
to allow the dyeing
completely.
8. Rinse the Vortex EZ with fresh water.
Note: The dyeing solution can be disposed of
down the drain. When doing so, please make
sure that you comply with wastewater disposal
regulations in your country/state/area.

Cleaning and maintenance

To increase the lifespan of the Vortex EZ or to change the
color, we recommend cleaning it after each emptying.
Caution: Be sure to disconnect the Vortex EZ
from the power supply before cleaning. Avoid
splashing water on the operating elements or
the power plug. Do not use abrasive or
aggressive cleaning agents for cleaning. Wear
protective gown, goggles and gloves.
To clean your device, follow these steps:
1. Follow the steps for disposing the solvent as
described before.
2. Open the lid and remove the basket. Rinse the
basket with water.
3. The device can be cleaned using a soft brush, soft
cloth or sponge. Use water and a household
cleaning agent. Rinse the device with clear water
afterwards. You can also set up a "dyeing bath"
Page 16
solution to drain off