Flushing The Solvent - XIONEER Vortex EZ Bedienungsanleitung

Flushing the solvent

The dyeing solution will become depleted once you dyed
several kilograms of your materials and will become
ineffective at dyeing further materials.
Note: Make notes on the amount of materials
dyed in order to renew the dyeing solution in
time.
Caution: Wear protective equipment (gown,
goggles and gloves) when emptying the tank.
Caution: Never empty dyeing solution while it is
still hot. Always wait until the dyeing solution has
cooled down.
When emptying the tank, make sure to follow these
steps:
1. Switch off the Vortex EZ and disconnect the
power plug. Allow the dyeing solution to cool
down.
2. Have another container ready if you do not have a
drain nearby. We recommend using a household
drain or a graywater container.
3. Never carry the Vortex EZ with the dyeing solution
inside!
4. Connect a hose to the valve on the left side of the
Vortex EZ. Make sure the hose is secured. Do not
use tools to tighten the connection.
5. Place the other end of the hose into a drain or gray
water container with a minimum capacity of 38
liters and secure the hose from falling out.
Page 15