Device Disposal; Troubleshooting - XIONEER Vortex EZ Bedienungsanleitung

Device disposal

To protect the environment, resources and your health,
we ask that you recycle the Vortex EZ responsibly.

Troubleshooting

The Vortex EZ does not have automatic fault detection.
There is a self-resetting heater fuse to prevent the unit
from overheating. Always make sure that there is always
enough liquid in the tank of the Vortex EZ.
If you can not detect any heating, switch off the device
and make sure that the water level is above "MIN"
indicator. Let the water cool down to room temperature
and switch on the device again. If no heating can be
detected, please contact customer service.
If you cannot detect any flow in the dyeing bath, make
sure that the propeller is turning. Switch off the device,
empty the basin and set the speed controller to 0. Fill
about 10 liters of fresh water into the basin and switch on
the unit. Slowly turn up the speed control knob. If there is
no rotation, turn off the unit, disconnect the power plug
and drain the water. Remove the propeller as described in
the "Maintenance" section and clean the area under and
around the propeller. Reinstall the propeller. Test again as
described above. If no rotation can be detected, please
contact customer service.
If you notice a leak in the container, switch off the device
and empty the container according to the steps
described in the sections before. Please contact the
customer service.
If needed, you can obtain replacement baskets and
propellers from customer service.
Page 18