Safety instructions and warnings
The following instructions must be observed when
operating the Vortex EZ:
•
For safe electric disconnection, pull the cold
appliance plug on the back of the device.
•
The Vortex EZ may only be operated with water
and recommended dyeing additives. Do not use
aggressive caustic solvents.
•
Never fill the Vortex EZ with flammable liquids,
liquids that produce flammable gases, or organic
solvents. This increases the risk of an explosion,
leading to injury and even death.
•
If you place the device next to a wall, please ensure
to keep a distance of at least 10 cm to the wall.
Make sure that the fan plates on the back of the
device are not blocked.
•
Vortex EZ may only be carried when empty.
Carrying with water or dyeing solution inside is not
permitted. Please empty the tank before each
transport.
•
Only place the Vortex EZ on a stable, straight, dry,
heat- and moisture-resistant surface that can
carry the weight of the device including its
contents (60 kg). Do not place the Vortex EZ on a
soft or unstable surface.
•
The Vortex EZ should only be used indoors in a dry
and well-ventilated environment. Make sure that
there is good ventilation in the room where you
operate the device.
Page 6