Operation - XIONEER Vortex EZ Bedienungsanleitung

Turn on the stirrer with the stirrer knob. The stirrer should
now begin to rotate audibly. You can regulate the stirring
speed. Turn the knob all the way to the right for maximum
rotation speed.
Close the lid of the container device. Use the large control
dial to set the desired temperature (maximum 85 °C).
Turn the dial clockwise to increase the temperature.
When the desired temperature is reached, the red lamp
next to the temperature control will switch itself off.
Caution: During operation, hot steam escapes
when the container is opened.

Operation

This section describes the operation of the Vortex EZ and
gives you an indicator for a usable temperature range
depending on the model and material of your 3D printed
object.
Page 11