Inserting/Replacing The Batteries; Shaving - Silvercrest SLS 3 A1 Bedienungsanleitung

Inserting/replacing the batteries

NOTE
► Always use 1.5 V, AAA type batteries.
► Pay attention to the correct polarity when inserting the batteries
1) Turn the lock
2) Now pull off the battery compartment cover
3) If inserted: Remove the discharged batteries
4) Insert new batteries
partment
5) Push the battery compartment cover
lock back.
The battery compartment

Shaving

NOTE
► If your skin is sensitive or prone to allergic skin reactions, try the shaver first
on a small, unobtrusive area.
1) Ensure the shaver unit
2) Press the travel lock, which is located on the on/off switch
on/off switch
The appliance starts.
The travel lock ensures that the appliance does not start up accidentally, for
example, when stowed away.
NOTE
► Before dry shaving, ensure that your skin is free of cream or oil residue.
Your skin should be clean and dry.
3) Hold the shaver perpendicular to the skin and guide the shaver unit
straight movements against the direction of hair growth. Apply repeatedly.
The small rubber lip in front of the shaving head
pulled tight and also causes the hairs to stand upright a little.
4) After you have covered all the areas you want to shave, push the on/off
switch back into its initial position. The appliance stops.
5) Clean the shaver after every use with the supplied cleaning brush
For a more thorough cleaning, read the section "Cleaning, care and mainte-
nance".
│ GB │ IE
■ 6
a quarter turn.
as shown in the polarity diagram in the battery com-
.
is now closed.
is attached and locked in place.
towards the shaver unit
together with the lock
from the battery compartment
back onto the appliance and turn the
.
ensures that the skin is
.
.
.
and push the
in
.
SLS 3 A1