Overhead Rigging - Futurelight WP-60 Bedienungsanleitung

The device must be installed out of the reach of people.
The device must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
Procedure:
Step 1: On the mounting-brackets, there are the holes for the installation.
Step 2: Attach the two mounting-brackets at the device's rear panel via the carriage bolts in order to
measure the minimum mounting distance between the two brackets.
Step 3: Remove the two mounting-brackets from the rear panel. Hold the brackets onto the location
where the device is to be installed – considering the calculated minimum mounting distance.
Step 4: Mark the boreholes with a pen or a suitable tool.
Step 5: Drill the holes.
Step 6: Attach the mounting-brackets at the wall and tighten the screws.
Step 7: Attach the device at the mounting-brackets.

Overhead rigging

Installation via the adapter plate
Insert the four quick-lock fasteners of the adapter plate into the respective holes on the bottom of the device.
Tighten the quick-lock fasteners fully clockwise.
The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
19/42 00032470.DOC, Version 1.1