Hendi 239391 Gebrauchsanweisung Seite 6

Preparations before using for the first time
• Remove all protective packaging and wrapping.
• Check to make sure the appliance is undamaged.
In case of incomplete delivery and damages.
Please contact supplier (See ==> Warranty).
• Clean the appliance before use (See ==> Cleaning
and Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and
heat resist surface that is safe against water
splashes.
Suitable cooking equipment
Bottom of cookware
Material
EN
Diameter of the bottom
Type of cookware
Note: Using a pan or pot that's not suitable for induction cooking may damage the appliance.
Operation
• Place a suitable pan or pot at the centre of the
heating surface of the appliance. (See --> Suitable
pans for the appliance).
Note: Do not place empty pan as this may damage
the pan and the appliance.
• Connect the power plug to a suitable electrical
supply outlet. On/Standby button (1) will be light
up and the appliance now in Standby mode.
• Then, switch On the appliance by pressing On/
Standby button (1) and Power button (6) will flash.
Setting Power level
• During operation, press the power button (6) to
activate. The indicator light (6) will light up.
• Use the increase setting (3) or decrease setting
6
• Ensure that there is sufficient ventilation. Keep
a minimum distance of 15 cm around the appli-
ance.
• Do not place the appliance in close proximity to
devices which are sensitive to disturbances by
magnetic sources (e.g. radios, tape decks).
Note: Due to manufacturing residues, the appli-
ance may emit a slight odor in the first few cycles.
This is normal and does not indicate any defect or
hazard. Make sure the appliance is well ventilated.
Suitable
Flat bottom
Cookware with iron, cast iron, mag-
netic stainless steel or enamelled iron
bottom.
Between 12 cm and 23 cm.
Cookware with a bottom thickness
over 1.5 mm.
• Next, choose to press either the power button (6)
or temperature button (7) to start cooking. If the
timer button (2) is not set, the appliance will op-
erate continuously.
• Once you have finished cooking, switch to Standby
mode by pressing the On/Standby button (1). The
digital display (4) and all buttons will go off except
On/Standby button (1).
Note: If no any button on the control panel is
pressed during operation for 2 hours, the appliance
will then switch to Standby mode automatically.
button (5) to increase or decrease the power level
(Range: 100W ~ 2,000W). Default setting is 100W.
Higher power level is suitable for steaming.
Not suitable
Curved, uneven, rounded bottom
Cookware with ceramic, glass, copper,
bronze, or aluminium bottom.
Less than 12 cm or more than 23 cm.
Completely closed containers or cans.