Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Switch the machine off if it stops for whatever reason. You avoid that it
starts suddenly and not under supervision.
Do not use the machine if a part of the housing is damaged or in case
of damages on the switch, the cable or plug.
During work, always lead the mains cable, extension cable and
extraction hose to the back away from the machine.
Power tools have to be inspected visually by a specialist in regular
intervals.
When using the drill, cooling water is never allowed to get into the
motor and all electrical parts.
Overhead-drillings only with suitable safety measures (water collection).
After an interruption of your work, only switch the machine on again
after having checked that the drill bit can be turned freely.
The tool may be used with the drill rig only.
Do not touch rotating parts.
Persons under 16 years of age are not allowed to use the tool.
During use, the user and other persons standing nearby have to wear
suitable ear protectors, goggles, helmets, protective gloves and boots.
Always work concentrated and carefully. Do not use the tool when
you are lacking in concentration.
For further safety instructions, please refer to the enclosure!
Fixing to Drill Rig
98
79,5
Fasten the gearing foot of the
EBM 300/3 P by means of four M 8
Allen screws to the drill rig.
The drill stand should have a good
stiffness and precise guide ways. The
spindle of the machine needs to go
parallel to the axle of the drill stand.
Use only fall-safe drill rigs.
It is advisable to use a water-collecting
ring.
21
Werbung
