Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Application for Indented Purpose
The diamond core drill EBM 300/3 P is indented for professional use and
may be used by instructed personnel only.
With the appropriate wet drill bits, the machine may be used for wet
drillings only, e.g. in concrete, stone and masonry.
It may be used with a suitable diamond drill rig only.
Safety Instructions
Safe work with the machine is only possible if you read
this operating instruction and follow the instructions
contained strictly.
Additionally, the general safety instructions of the leaflet
supplied with the tool must be observed. Prior to the
first use, the user should absolve a practical training.
If the mains cable gets damaged or cut during use, do not
touch it, but instantly pull the plug out of the socket. Never
use the tool with a damaged mains cable.
When drilling in ceilings or walls make sure you will not cut
through electrical mains, gas or water pipes. Use metal
detection systems if needed.
Prior to the start of your work, consult a statics specialist to
determine the exact drilling position.
If drilling through ceilings, secure the place below, because
the core may fall downward.
Pay attention that the tool is not exposed to directo rain.
Do not use the tool in an environment with danger of explosion.
Do not use the tool standing on a ladder.
Do not drill in asbestos-containing materials.
Never carry the tool at its cable and always check the tool, cable and
plug before use. Have damages only repaired by specialists. Insert the
plug into the socket only when the tool switch is off.
Modifications of the tool are prohibited.
The machine should only work under supervision of sbd. Plug and
switch the machine off if it is not under supervision, e.g. in case of
putting up and stripping down the machine, in case of voltage drop or
when fixing or mounting an accessory.
20
Werbung
