Description Of The Appliance; Preparation For Use - eta Delizio Bedienungsanleitung

EN
– The power cable supplied with the appliance is designed solely for this appliance - never
use it for any other purposes. Also, this appliance may only be used with the power cable
included in the box. Never use any other cable type (e.g. for a different appliance).
– Never put the power cord on hot surfaces or do not let it hang over the edge of a table
or a work top. Plugging or pulling the power cord e.g. by children can result in tilting over
or drawing the appliance down and serious injury!
– The power cord must not be damaged with sharp or hot objects, open fire, it must not
be sunk into water or bent over sharp edges.
II. DESCRIPTION OF THE APPLIANCE
A – The machine body
A1 – main ON / OFF switch
A2 – heating surface
A3 – milk frother (steam nozzle)
A4 – milk frother cover
A5 – metal tube
A6 – power cord
B – Control panel
B1 – steam nozzle button
B2 – button for two cups
B3 – button for one cup
B4 – rotary knob for setting functions
III. PREPARATION FOR USE
Before first use, remove any packaging and protective material (including any protective film)
from the appliance and accessories. Wash the water tank D with warm soap water, rinse it
with clean water and allow it to dry. Put it into the coffee machine again and press it down as
far as it goes.
Location
Place the coffee machine onto a flat and stable surface, near a socket. Keep a minimum
distance of 15cm from any wall at all sides.
Filling the tank with water
Remove the D tank from the coffee machine and fill it with water, preferably at room
temperature (the water level must be between the MIN and MAX marks). Then put the tank
back in place.
Removing operational components
Looking at the camera that is used more often with the coffee machine (metal lever C, drip
tray E), proceed as shown in Fig. 1, 2. Proceed in reverse order to put the components back.
Rinsing the coffee maker
At the first start-up or if you have not used the coffee machine for more than 2 days, flush it
using the following procedure:
1. Fill tank D with water up to the MAX mark.
C – Metal lever with plastic handle
C1 – funnel
C2 – stainless steel bowl for one cup
C3 – stainless steel bowl for two cups
C4 – auxiliary handle preventing falling
out of the bowl when emptying the
coffee grounds
D – Water tank
E – Drip tray
E1 – drip grille
F – Coffee measuring cup with stamper
22 / 51