eta Delizio Bedienungsanleitung Seite 24

EN
3. Activate the steam nozzle by pressing button B1. Nozzle heating is indicated by blinking
the backlight of button B1. When the nozzle is ready, the backlight of button B1 is
permanently on. Turn regulator B4 to „
4. Then place the milk container under the steam nozzle so that the nozzle opening
slightly touches the milk level and let the steam flow into the milk slowly by turning it
counterclockwise. Switch off the steam wand by pressing the B1 button again or turning
the B4 control to the „ " position.
5. Pour the frothed milk carefully over the coffee based on the espresso beverage you
have selected; you can use a teaspoon to do so.
6. Make sure to clean the milk frother immediately after use (components A3, A4, A5) see
chapter MAINTENANCE (for basic fast cleaning we recommend that you activate the
steam nozzle again for a short time). Milk-caked frother is harder to clean.
– For optimum micro-froth production, we recommend that you use a special milk pot
intended for that purpose.
– Another way to make micro-froth (but not larger dense froth) is to tilt the container at
a slight angle, not move it and allow the steam to stream into the container, creating an
eddy.
INDIVIDUAL INSTALLATION OF COFFEE QUANTITY
The amount of coffee can be adjusted both for two cups (25-200 ml - button B2) and for
one cup (25-100 ml - button B3). The procedure is as follows:
1. Turn the B4 knob to the „ " position and switch the coffee machine on by turning the
A1 switch to the „I" position and wait for it to warm up (the backlight of the buttons will
be permanently lit).
2. Turn the B4 knob to the „
3. Then press and hold the B2/B3 button until the desired quantity of coffee flows out.
When the desired amount of coffee is flowing, release the button.
4. The setting will be saved in the coffee machine memory and will remain stored even
after the coffee machine is switched off and unplugged. network.
– If you hold the B2/B3 button too short, your settings will not be saved.
– Make the following steps to return to factory setting:
1. Be sure the coffee machine is connected to electricity supply.
2. Turn rotary switch B4 to „
3. Set the main switch A1 to position ‟O"(off).
4. Press and hold simultaneously buttons B1 and B3, and at the same time, set the
main switch A1 to position ‟I"(on).
5. Then release buttons B1 and B3.
6. Signal lamps of buttons B2 and B3 start flashing blue alternately.
7. Use main switch A1 to switch the coffee machine on, and then off.
8. Turn rotary switch to „ ".
9. Signal lamps of buttons B1 and B2 will be flashing blue and signal lamp of button
B3 will be flashing blue and red.
10. Then press button B3 and wait until the signal lamps of all buttons start flashing
blue. In this way, factory setting has been restored and the coffee machine can
be normally used.
" and steam nozzle A3 will produce steam.
Recommendation
" position.
Remarks
".
24 / 51