Merax MS304749-8090 Benutzerhandbuch Seite 18

2. Remove the 4 covers from the column and insert the left and right handlebars into the corresponding
positions of the column. And use 5mm inner hexagon wrench and the 2 M8*50 screws to secure them
onto the column respectively. Place the 2 plugs back into the square hole and keep the other two in
place.
3. Insert the phone/tablet holder into the slot
There are 6 adjustable foot pads at the bottom of the machine, which can be adjusted according
to the flatness of the ground. Make sure that all the foot pads are on the ground, otherwise
abnormal noise or unnecessary damage may be caused to the user during exercise.
4. Put the safety key in the position as shown in the picture and press the start button to start using the
machine. (Note: The treadmill can only be started normally only if the safety lock is placed on the
yellow area of the bottom of the console)
Note: please confirm that all screws are locked uniformly according to the requirements after
installation, and check no part is left out before plugging electricity.
Note: the safety key is in red
color. Please find it in the
accessory bag and put the
magnet end on the yellow area
of the console!
5
M8*50
18